Webthing-python threading problem with mraa gpio interrupt

[marcgraham]

take a look at this:

How to use a interrupt pin with webthing-python

I have a webthing programmed in python and used with v3.7. It’s a LED-Strip that can turn on/off and dim over pwm. Now I’m thinking of hooking a PIR sensor to a pin with interrupt signaling and let the LED-Strip turn on when ever the motion detection (of that PIR sensor) signals presence of motion in the room and off after a timeout ends. Do I have to spin up a new thread through treading.event().wait(timeout=x..) to not block the other features or is there some built in techniques to do so i…

You should try searching discuss for examples.